Kids & Junior

Skate & Kids Helmets

Skate, scooter and children's helmets built on the same in-mould and ABS lines as the adult ranges, in smaller shells and smaller size steps. Retention is dial-fit, so one model covers a two to three centimetre head circumference band and grows with the child. Decoration is where these programmes are won: water decals, transfer graphics and print-to-order artwork are all available from 500 pieces.

  • EN 1078 tested models
  • 16 CFR 1203 tested model
  • GB 24429-2009 tested model
  • Kids' size range
Kids skate and scooter helmet - Spoton factory model
Models

Skate & Kids Models

Skate and kids' programmes are quoted per project. Send your headform sizes and artwork, and we will come back with the shells that already fit your range.

Certification

Testing Status

Only the standards we can produce a report for are listed here. Full reports available on request.

Certification

Skate and kids' helmets run on the same standards as the adult ranges, but which one applies depends on the market and on the age group. EN 1078:2012+A1:2012 covers pedal cyclists, skateboard and roller skate users in a single scope, so one test report can support all three uses across the EU. For very young children, the separate standard EN 1080 covers helmets with a play release system that opens under a defined load, so a child cannot be strangled by the strap while playing — worth checking if you sell into nursery or playground channels. The US market runs through 16 CFR 1203, and China through GB 24429-2009, the mandatory standard for cycling, skateboard and roller skate helmets. Tell us the destination and the age range and we will confirm which route applies, with the report on the table, before you commit to an order.

Other Categories

Explore the Rest of the Range

Ready to Quote Skate & Kids?

Send us your target market, age range and volumes — we reply within 24 hours.

Request a Quote